Description
HydrO2’s simple spray and rinse application saves time and creates a durable silica coating with a brilliant shine that is easy to maintain. Its “Hydroelectric bonding” process is activated by contact with water, transforming the coating from hydrophilic to hydrophobic. Rinsing with water pressure helps HydrO2 bond to the surface and form a water-repellent layer.
HydrO2 performs across a range of climates and temperatures. It provides long-lasting water repellency, resistance to many acids, alkaline solutions and solvents, and significant UV protection.
Directions:
-
Do not apply HydrO2 in direct sunlight or to a hot surface. This may cause streaks that are difficult to remove.
-
In a shaded area or shop, wash the vehicle and remove dirt from all surfaces. CarPro Snow Soap is recommended for best results.
-
Rinse away all soap residue and leave the surface wet.
-
Dilute 1 part HydrO2 with 6 parts water. The supplied measuring cap holds 30 mL. A spray bottle is recommended for easy application.
-
Spray a fine mist of diluted HydrO2 onto no more than one-quarter of the vehicle at a time. Only a small amount is needed; overlapping sprays are unnecessary.
-
Rinse each section within one minute of spraying.
-
Immediately rinse thoroughly with strong water pressure to help form the coating.
-
Repeat steps 5–7 on the remaining sections, rinsing each section before moving to the next.
-
Finish by rinsing the vehicle from top to bottom without a spray nozzle, allowing the water to flow over the surface.
-
Remove any remaining water with a blower or a clean waffle weave towel.